Tascam DM-4800 Manual

Also see for DM-4800: Manual Software guide Specification sheet Owner's manual Technical documentation

Effect parameter list TASCAM DM-4800 Effect listParameter Indicator Range Description RemarksOutput wetcross feedWet X-Feed 0% - 100% (1% steps) Specifies pan for L/R wetchannel outputs.With 0%, L channel wetsignal is output from Lchannel, and R channelwet signal is outputfrom R channel. With100%, L channel wetsignal is output from Rchannel and R channelwet signal is outputfrom L channel.Mixture Mixture 0% - 100% (1% steps) Specifies mix ratio ofdry feedback delay sig-nal and LFO modulationsignal.MONO FLANGER FX2.0This flanger effect features mono-in and stereo-out.It uses the same algorithm as the chorus effects, andthe parameters are identical to the mono chorus pa-rameters.Table 1.3: Mono Flanger parametersParameter Indicator Range Description RemarksLFO rate LFO Rate Freeze, 0.01 Hz - 30.00 Hz (0.01 Hz steps) Specifies LFO frequency.LFO depth LFO Depth 0.0% - 100.0% (0.1% steps) Specifies LFO modula-tion depth.Pre-delay Pre-Delay 0 ms - 500 ms(0 ms - 9.99 ms: 0.01 ms steps;10 ms - 99 ms: 1 ms steps;100 ms - 500 ms: 10 ms steps)Specifies time betweenonset of original soundand onset of the effectsound.Using this parameterenables you to makeinteresting and detailedsettings based on subtlechanges due to phasecancellation.FeedbackamountFeedbkAmt 0% - 90% (1% steps) Specifies amount ofdelay line output signalreturned to delay lineinput.FeedbackinversionInvertFbk Off, On Determines whetheror not feedback pathoutput signal will beinverted.LFO waveformtypeLFO Type Off, Sine, Triangle, Sawtooth Up, SawtoothDown, SquareSpecifies LFO waveformtype.LFO softening LFO Smooth 0.0% - 100.0% (0.1% steps) Specifies low-pass filtercoefficient applied toLFO waveform.This parameter improvesunnatural sound atdiscontinuous points bysmoothening out edgesof sawtooth or squarewaveform.Dry delay DryDly(Thru 0)0.0% - 100.0% (0.1% steps) Specifies delay of drysignal that simulates“ through zero” flanging.