TASCAM DR-40 132 – Names and Functions of PartsFront panels EXT MIC/LINE IN L/R jacks (XLR/TRS)These are balanced analog XLR/TRS combo jacks formicrophone and line level inputs.XLR (1: GND, 2: HOT, 3: COLD)TRS (Tip: HOT, Ring: COLD, Sleeve: GND)CAUTION• Confirm that phantom power is OFF before connecting aline level device to a EXT MIC/LINE IN jack. If you connecta line level device while phantom power is being supplied,that device and this unit could be damaged.• Do not connect or disconnect mics with the EXT MIC/LINEIN jacks when the phantom power switch is set to ON.Doing so could cause a loud noise and might damage thisunit and connected equipment.• Set the phantom power switch to ON only when usinga condenser microphone that requires phantom power.Turning phantom power on when a dynamic mic or othermic that does not require it is connected could damage thisunit and connected equipment.• When using condenser mics that require phantom powerand dynamic mics together, be sure to use balanceddynamic mics. Unbalanced dynamic mics cannot be usedwhen phantom power is enabled.• Supplying phantom power to some ribbon mics will breakthem. If you are unsure, do not supply phantom power to aribbon mic.d REMOTE jack (2.5 mm dia. TRS jack)Connect a TASCAM RC-3F footswitch or TASCAM RC-10wired remote control (both sold separately) here to enableremote starting and stopping of playback and otherfunctions.
