Tascam DR-701D Reference Manual

Also see for DR-701D: Owner's manual Manual Owner's manual

14 TASCAM DR-701D3 – PreparationUsing USB bus powerConnect the unit to a computer using the included USB cable asshown in the illustration.Connect the included USB cablemicro-B USB plugComputerIf the USB cable is connected while the unit is on or the unitis turned on with the USB cable already connected, the USBSELECT screen will appear. Choose between USB bus powersupply or computer connection on this screen.Turn the DATA dial to select BUS POWER and press the DATAdial to enable power supply from the USB port. The HomeScreen will appear.NOTEPower is supplied from the USB port if the USB cable isconnected to the unit even when it contains batteries (USBbus power prioritized).CAUTION• Depending on the USB bus power specifications of thecomputer, this unit might not function when connectedto the computer by USB cable. In this case, use a TASCAMPS-P515U AC adapter (sold separately) or batteries.• This unit does not support computer power conservationand sleep functions. When powering the unit using the USBbus power of a computer, always turn such functions off.Turning the power on and off (puttingit in standby)CAUTION• The unit enters standby mode if shut down when the unitis operating on AC power supplied through a TASCAMPS-P515U AC adapter (sold separately) or bus powersupplied from a computer USB port.• Turn down the volume of the monitoring system connectedto the unit before turning the unit on/off (standby).• Do not use headphones when turning the unit on/off(standby). Loud noises could damage the speakers or harmyour hearing.Turning the unit onTo start the unit when off (in standby), slide the HOLD/switch toward until "TASCAM DR-701D" (start-up screen)appears on the display.The Home Screen appears after the unit starts up.Start-up Screen Home ScreenCAUTIONWhen the unit is started up for the first time (or whenthe built-in clock is reset after being left unused withoutbatteries), the DATE/TIME screen appears before theStart-up Screen so you can set the date and time.(see“Setting the date and time” on page 15)Turning the unit off (putting it in standby)When on, slide the HOLD/ switch toward .The unit turns off (enters standby) after it completes itsshutdown process.CAUTIONAlways use the HOLD/ button to turn the unit off (put itin standby).While the unit is on, do not remove the batteries, disconnectthe power cord when using a TASCAM PS-P515U AC adapter(sold separately) or disconnect the USB cable when usingUSB bus power. Doing so will cause all recordings, settingsand other data to be lost. Lost data and settings cannot berestored.Resume functionThis unit has a resume function. When started up, the unitlocates to the position (time) where it was when turned off (putin standby) previously.After the unit is turned on, playback is possible from theposition (time) it was at when the 2/7 button was pressed toturn the unit off (put it in standby).NOTEThis data is stored on the SD card. The resume function willnot work if the card is changed or formatted.