TASCAM SS-CDR200/SS-R200/SS-R100 15Rear panelSS-CDR200/SS-R200SS-R100g ANALOG L/R INPUTS (BALANCED)(SS-CDR200/SS-R200 only)These balanced analog XLR input connectors have anominal input level of +4 dBu.(1: GND, 2: HOT, 3: COLD)h ANALOG L/R INPUTS (UNBALANCED)These analog RCA pin input jacks have a nominal inputlevel of −10 dBV.j ANALOG L/R OUTPUTS (UNBALANCED)These analog RCA pin output jacks have a nominaloutput level of −10 dBV.k ANALOG L/R OUTPUTS (BALANCED)(SS-CDR200/SS-R200 only)These balanced analog XLR output jacks have anominal output level of +4 dBu.(1: GND, 2: HOT, 3: COLD)l DIGITAL IN (COAXIAL)This digital input jack accepts inputs in IEC60958-3 (S/PDIF) and AES3-2003/IEC60958-4 (AES/EBU) formats(detected automatically).To link two of these units together, connect theDIGITAL OUT jack of the other SS-CDR200/SS-R200/SS-R100 to this connector. (See “Link playbackconnections” on page 38.); DIGITAL OUT (COAXIAL)This digital output jack can output IEC60958-3 (S/PDIF) and AES3-2003/IEC60958-4 (AES/EBU) formatsaccording to the unit’s setting.To link two of these units together, connect theDIGITAL IN jack of the other SS-CDR200/SS-R200/SS-R100 to this connector. (See “Link playbackconnections” on page 38.)z CONTROL I/O RS-232C connector(SS-CDR200/SS-R200 only)This 9-pin D-sub I/O connector for RS-232C control canbe connected to a computer or other external device.(See “Using the RS-232C connector” on page 75.)x CONTROL I/O PARALLEL connector(SS-CDR200/SS-R200 only)25-pin D-sub I/O connector for parallel control can beused to connect an RC-SS20 (sold separately) or otherexternal controller.For pin assignments and other information, see “Usingthe parallel connector” on page 75.c REMOTE IN connectorConnect the included TASCAM RC-SS2 wired remotecontrol, which is designed for use with this unit, here.v AC IN connectorConnect the included power cord here.2 − Names and functions of parts