English 2. Features and controls6 TASCAM XS-32.1. Top Panel1 MIC LEVELAdjusts the MIC input signal level.2 MIC EQ2-band EQ for microphone input signal.3 TRIMAdjusts the input signal level of each PGM.All input sensitivity adjustment must be done byvery carefully using level meter and/or head-phones as a reference and avoiding that all thered LEDs of the level meter light up, otherwiseinput could be clipped (overload).4 PGM EQ3-band EQ for each PGM signal.When all EQ are set to -26 dB, the sound will be cutfully.5 C.F REVERSESets the direction of CROSS FADER operation.OFF: Moving the CROSS FADER towardA makes A signal louder and movingthe CROSS FADER toward B makesB signal louder.REVERSE: Moving the CROSS FADER towardA makes B signal louder and movingthe CROSS FADER toward B makesA signal louder.6 C.F CURVEAllows you to adjust the PGM 2 FADER responsecurve from soft (counter-clockwise) to hard (clock-wise).7 PHONO/LINESelects the input signal (PHONO or LINE) of eachPGM.8 PGM FADERAdjusts the PGM level.9 MASTER LEVELAdjusts MASTER OUT 1 (balanced TRS and unbal-anced RCA connectors) output level.0 EFFECT switch and LEDActivates the external effect path of MASTER whenEFFECT switch is turned on. When effect path is acti-vated, LED will light up.NOTEq MONITOR MASTER/CUESelects the way of monitoring in the headphones.CUE: This way allows you to monitor thePGM signals adjusted by cue balancefader.MASTER: This way allows you to monitor thepre MASTER volume signal.w LEVELAdjusts the headphone output level.e CUE BALANCEAdjusts the balance between PGM 1 and PGM 2 signalin the headphones.r CROSS FADERMixes the PGM 1 and PGM 2 signals.CROSS FADER is user replaceable. It is possible toset the CROSS FADER curve and reversal.t INPUT LEVEL METERIndicates the signal level of each PGM.LEVEL METER indicates the post PGM FADERsignals.2.2. How to replace the fader1. Remove the two screws from the fader panel sur-face.2. Remove the fader.3. Unplug the multi-cable connector that connected tothe fader.4. Plug in the multi-cable connector to a new fader.5. Replace the fader with the screws.2.3. Rear Panely EFFECT (unbalanced TRS jack)Inserts the external effect in STEREO OUTPUT signalpath. Connect the external effector to this jack.Connections are follows:SEND: TipRETURN: RingGND: SleeveNOTE