Teac P-70 Owner's Manual

Also see for P-70: Service manual

Contents

Teac P-70 Owner's Manual Manual pdf 13 page image

Settings13ENGLISHUse this when you want to use a central word synchronizationsource, such as the TEAC D-70, which outputs a word clock(word sync).Using the WORD SYNC switch of the player, change ON andOFF.< This player can respond to synchronization signals at either44.1kHz or 88.2kHz, and automatically changes depending onthe input signal.< With playback stopped, and the word sync connection made,set this switch to ON. The WORD SYNC indicator flashes as itsearches for an external synchronization signal. When lockedto the synchronization signal, the indicator lights steadily.Playback with external synchronization is now possible.About the PLL filter< The PLL filter switch, on the rear panel of the unit, is set toMODE 1 when the unit is shipped from the factory. Typically,you should use MODE 1.< In MODE 2, the PLL filter cutoff frequency is approximately tentimes that of MODE 1. Jitter is almost completely eliminated.When you want a very accurately synchronized signal, selectMODE 2.< MODE 2 takes significantly longer to achieve lock statuscompared with MODE 1. If lock status cannot be achievedusing MODE 2, change back to MODE 1.You can convert the basic 44.1kHz sampling frequency todouble (88.2kHz) or four times (176.4kHz).Set the UP CONVERT switch to ON, and then select either 4Fs(four times) or 2Fs (double) frequency.< If you select 4Fs (four times), the unit outputs the R channel at88.2kHz from XLR1(R) and the L channel at 88.2kHz fromXLR2(L). When these are added together, the total samplingfrequency is 176.4kHz.< When you use this setting, you should use two XLR cables toconnect the R terminals of the player and the D/A converter,and the L terminals of the player and the D/A converter. Notethat even if two XLR cables are connected, when the UPCONVERT switch is OFF, or 2Fs is selected, general stereosignals are output from both XLR terminals.< If a D/A converter does not correspond to the dual AESstandard, or can only be connected using an RCA terminal oran optical terminal, it is not possible to use 4 x samplingfrequency, and you must select 2Fs (88.2kHz).< Note that if 4Fs is selected, no digital audio is output from theRCA or OPTICAL terminals.WORD SYNC UP CONVERT