Operator's Manual Sixth Edition • First PrintingControls28 Z®-45/25J Part No. 1299167GT1 LCD readout screenScreen displays hour meter, voltage, oilpressure and coolant temperature. Screenalso displays fault codes and other serviceinformation.2 Engine start switchMove the engine start switch to either side tostart the engine.3 Not used4 Not used5 Engine idle (rpm) select switchMove the engine idle select switch to the turtleposition for foot switch activated low idle.Move the engine idle select switch to the rabbitposition for foot switch activated high idle.6 Not used7 Turntable rotate switchMove the turntable rotate switch to the rightand the turntable will rotate to the right. Movethe turntable rotate switch to the left and theturntable will rotate to the left.8 Auxiliary lowering switchUse auxiliary power if the primary powersource (engine) fails.Simultaneously hold the auxiliary power switchto either side and activate the desired function.9 Platform rotate switchMove the platform rotate switch to the rightand the platform will rotate to the right. Movethe platform rotate switch to the left and theplatform will rotate to the left.10 Platform level switchMove the platform level switch up and the levelof the platform will raise. Move the platformlevel switch down and the level of the platformwill lower.11 Platform overload indicator light12 Light flashing indicates the platform isoverloaded. The engine will stop and nofunctions will operate. Remove weight until thelight goes off and then restart the engine.13 Function enable buttonPress and hold the function enable button toenable the functions on the ground controlpanel to operate.14 Jib boom up/down switchMove the jib boom switch up and the jib boomwill raise. Move the jib boom switch down andthe jib boom will lower.15 Primary boom extend/retract switchMove the primary boom extend/retract switchto the right and the primary boom will retract.Move the boom extend/retract switch to the leftand the primary boom will extend.