T+A S10 User Manual

T+A S10 User Manual Manual pdf 40 page image

40Approved usageThis device is designed exclusively for reproducingsound and/or pictures in the domestic environment. It isto be used in a dry indoor room which meets all therecommendations stated in these instructions.Where the equipment is to be used for other purposes,especially in the medical field or any field in which safetyis an issue, it is essential to establish the unit’s suitabilityfor this purpose with the manufacturer, and to obtain priorwritten approval for this usage. equipment which includes a radio or televisionreceiving section must be operated within the stipulationslaid down by the Post Office and the Telecommunicationsauthorities in the country in which it is used.This unit may only be used to receive or reproduce thosetransmissions which are intended for public reception.The reception or reproduction of other transmissions (e.g.police radio or mobile radio broadcasts) is prohibited. The only permissible method of disposing ofthis product is to take it to your local collectioncentre for electrical waste.Care of the unit:Disconnect the mains plug from the wall socket beforecleaning the turntable.To clean the machine simply wipe the surfaces with asoft, damp cloth or sponge. Do not rub the surfaces witha dry cloth. Please just use clean water to moisten thecloth, or water with a small addition of a mild cleaningagent such as a neutral cleaner, soft soap or similar.Never use any organic solvent which might containmaterials such as paint thinners, alcohol or lighter fuel.Before using the unit again be sure to check that thereare no short-circuits at the connections, and that all con-nectors are correctly fitted and firmly inserted.Approval and conformity with ECdirectivesIn its original condition the unit meets all currently validEuropean regulations. It is approved for use as stipulatedwithin the EC.By attaching the CE symbol to the unit  declares itsconformity with the EC directives 2006/95/EC and2004/108/EC and the national laws based on thosedirectives.The original, unaltered factory serial number must bepresent on the outside of the unit and must be clearlylegible! The serial number is a constituent part of ourconformity declaration and therefore of the approval foroperation of the device.The serial numbers on the unit and in the original documentation supplied with it (in particular theinspection and guarantee certificates), must not beremoved or modified, and must correspond.Infringing any of these conditions invalidates conformity and approval, and the unit may not beoperated within the EC. Improper use of the equipmentmakes the user liable to penalty under current EC andnational laws.Any modifications or repairs to the unit, or any otherintervention by a workshop or other third party notauthorised by , invalidates the approval andoperational permit for the equipment.Only genuine  accessories may be connected to theunit, or such auxiliary devices which are themselvesapproved and fulfil all currently valid legal requirements.When used in conjunction with auxiliary devices or aspart of a system this unit may only be used for thepurposes stated in the section 'Approved usage'.FCC Informationto the user(for use in the United States of America only)Class B digital device – instructions:Note: This equipment has been tested and found tocomply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection againstharmful interference in a residential installation. Thisequipment generates, uses and can radiate radiofrequency energy and, if not installed and used inaccordance with the instructions, may cause harmfulinterference to radio communications. However, there isno guarantee that interference will not occur in aparticular installation. If this equipment does causeharmful interference to radio or television reception,which can be determined by turning the equipment offand on, the user is encouraged to try to correct theinterference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment andreceiver.- Connect the equipment into an outlet on a circuitdifferent form that to which the receiver is connected.- Consult the dealer or an experienced radio/TVtechnician for help.