Ubiquiti airFiber 5 User Manual

Also see for AF-5U: Quick start guide Quick start guide Quick start guide Manual

45Appendix D: Compliance InformationairFiber® AF5/AF5U User GuideUbiquiti Networks, Inc.Appendix D: ComplianceInformationInstaller Compliance ResponsibilityDevices must be professionally installed and it is theprofessional installer’s responsibility to make sure thedevice is operated within local country regulatoryrequirements.FCCChanges or modifications not expressly approved by theparty responsible for compliance could void the user’sauthority to operate the equipment.This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received,including interference that may cause undesiredoperation.NOTE: This equipment has been tested and foundto comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection againstharmful interference when the equipment is operated ina commercial environment. This equipment generates,uses, and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructionmanual, may cause harmful interference to radiocommunications. Operations of this equipment in aresidential area is likely to cause harmful interferencein which case the user will be required to correct theinterference at his own expense.Industry CanadaCAN ICES-3(B)/NMB-3(B)To reduce potential radio interference to other users, theantenna type and its gain should be so chosen that theequivalent isotropically radiated power (e.i.r.p.) is not morethan that permitted for successful communication.This device complies with Industry Canada licence-exemptRSS standard(s). Operation is subject to the following twoconditions:1. This device may not cause interference, and2. This device must accept any interference, includinginterference that may cause undesired operation of thedevice.CAN ICES-3(B)/NMB-3(B)Pour réduire le risque d’interférence aux autresutilisateurs, le type d’antenne et son gain doivent êtrechoisies de façon que la puissance isotrope rayonnéeéquivalente (PIRE) ne dépasse pas ce qui est nécessairepour une communication réussie.Cet appareil est conforme à la norme RSS Industrie Canadaexempts de licence norme(s). Son fonctionnement estsoumis aux deux conditions suivantes:1. Cet appareil ne peut pas provoquer d’interférences et2. Cet appareil doit accepter toute interférence, y comprisles interférences qui peuvent causer un mauvaisfonctionnement du dispositif.RF Exposure WarningThe antennas used for this transmitter must be installed toprovide a separation distance of at least 126 cm (AF-5) or123 cm (AF-5U) from all persons and must not be locatedor operating in conjunction with any other antenna ortransmitter.Les antennes utilisées pour ce transmetteur doivent êtreinstallé en considérant une distance de séparation detoute personnes d’au moins 126 cm (AF-5) ou 123 cm(AF-5U) et ne doivent pas être localisé ou utilisé en conflitavec tout autre antenne ou transmetteur.Australia and New ZealandWarning: This is a Class B product. In a domesticenvironment this product may cause radio interferencein which case the user may be required to take adequatemeasures.CE MarkingCE marking on this product represents the product is incompliance with all directives that are applicable to it.Alert sign! follows CE markingAlert sign must be indicated if a restriction on use appliedto the product and it must follow the CE marking.The product can be operated in the countries and regionslisted in this table: “Frequency Ranges and Power Levelsper Country/Region” on page 46, within the statedfrequency ranges and output power (EIRP) limits.