Ultra Start 15 SERIES Install Manual

Also see for 15 SERIES: Owner's guide Owner's guide

Contents

Ultra Start 15 SERIES Install Manual Manual pdf 21 page image

Transmitter ProgrammingStep 1 - Within 3 seconds turn the ignition ON-OFF-ON-OFF-ON - Leaving Key ONStep 2 - Press and hold the Program Button - The park lights will turn ON and the horn(optional) will honk once.*Continue to hold the Program Button, the park lights will turn off and the horn will honk 5 times quickly.Step 3 - While holding the Program Button, press the LOCK button on each of the remote’s to be programmed.If remote’s are being programmed for 2nd Car Operation press the # button on each of the 2nd carremote’s to be programmed.Note: The park lights will flash once and the horn will honk once each time a new code is learned.Note: Transmitter programming must done quickly. Do not pause more than one second between each transmitter.All the transmitters to be used must be programmed at the same time. All transmitters not programmedat this time will be erased from memory for security. The system holds a maximum of 4 transmittercodes including 2nd car remote codes.*If the Park Lights do not turn ON, turn ignition OFF, wait 5 seconds and repeat steps 1&2Carefully removethe screw from theback of the remote.Remove the top caseThen replace thebattery.Replace top case.Re-install screw.Test remote forproper operation.Battery ReplacementThe transmitter battery should be changed at least once every year to maintainproper operating range. Replace with quality23A 12volt Alkaline battery.Ignition 3xOn/OffOn/Off OnPress andHOLD theProgramButtonPress theLock ButtonPress theLock ButtonPress the# ButtonPress the# ButtonSingle Car Operation, Programup to 4 remote’sDual Car, Control 2 Ultra Startvehicles with the same remotePage 21REMOTE VEHICLE STARTER INSTALLATION MANUAL

/ 24

Related manuals for Ultra Start 15 SERIES