Ultra Start 15 SERIES Install Manual

Also see for 15 SERIES: Owner's guide Owner's guide

Contents

Ultra Start 15 SERIES Install Manual Manual pdf 24 page image

DIAGNOSTICSIf the remote starter does not activate when the start button is pressed the park lightswill flash a diagnostic to indicate what shutdown input has been triggered. For examplewhen the start button is pressed the park lights flash 3 times slowly. Looking at the chartbelow this would indicate that the system is in Service Mode, simply follow theinstructions listed in the owners manual on exiting Service Mode and the remote starterwill begin to function as normal.PARK LIGHTS STATUS LED DIAGNOSTIC CODE3 Flashes Series of 3 Flashes Door Opened “M” Models3 Slow Flashes LED’s On Solid System Is In Service Mode4 Slow Flashes Series of 4 Flashes Not in Reservation Mode “M” units5 Flashes Series of 5 Flashes Hood Pin Opened5 Slow Flashes Series of 5 Flashes Ignition On During Start Attempt6 Flashes Series of 6 Flashes Brake Pedal Shutdown7 Flashes Series of 7 Flashes Tach Lock-OutDIAGNOSTIC MEMORYLED Flashes Diagnostic5 Flashes The system was shutdown by the brake switch input6 Flashes The system was shutdown by the hood pin input7 Flashes The system did not detect the tach signal.8 Flashes The system made 3 start attempts without startingBeing that the installer does not always see when the system shuts down or fails tostart, Diagnostic Memory will store in memory up to four shutdown codes.This information can then be accessed to determine the source of the shutdown.To Enter Diagnostic Mode:Step 1 - Turn the ignition on then turn off. Press the Program Button and release.Step 2 - The system will respond with three park light flashes and the horn will honk(optional) the same number of times as the events in memory.Maximum four events, four honksNOTE: If the horn does not honk, there are no events in memory.Step 3 - Press the Program Button once to view the last shut down code. The (optional)Horn will honk once to confirm code one.If the horn does not honk, there are no codes in memory.Step 4 - The LEDs on the antenna will flash a code corresponding to a shut down trigger.Press the Program Button again to check the second code.The horn will honk twice to confirm code two.Step 5 - To Clear Diagnostic Memory. While in Diagnostic Mode press and hold theProgram Button for five seconds.The park lights will flash and the horn(optional) will honk once.NOTE: Once diagnostic memory has 4 shutdown events in memory, the system will notRecord any further shutdown events until the system memory has beencleared.Page 24INSTALLATION MANUAL REMOTE VEHICLE STARTER

/ 24

Related manuals for Ultra Start 15 SERIES