Ultra Start 450 SERIES Owner's Manual
Also see for 450 SERIES: Owner's guideInstall guide
            | |
ALARM STATUS / DIAGNOSTICSALARM STATUS / DIAGNOSTICSSIREN CHIRPS LED FLASHES DIAGNOSTICS / STATUS3 2 SHOCK SENSOR TRIGGER3 3 DOOR / HOOD TRIGGER3 4 IGNITION TRIGGER0 OFF SYSTEM DISARMED0 ON SOLID SYSTEM IN VALET / SERVICE MODE0 SINGLE FLASHES SYSTEM ARMED0 RAPID FLASHES PASSIVE ARM COUNTDOWNLED FLASHES OUTPUT DIAGNOSTICS2 LOCK OUTPUT OVERLOAD3 UNLOCK OUTPUT OVERLOAD4 TRUNK OUTPUT OVERLOAD5 STARTER DISABLE OVERLOAD6 NOT USED7 AUX 5 OUTPUT OVERLOAD8 2ND UNLOCK OUTPUT OVERLOADIf the alarm system is triggered, the system will retain in memory the cause of thetrigger. When disarming the alarm, the siren/horn will chirp 3 times to indicatethe alarm had been triggered. The system’s LED will also flash in pulses toindicate which input triggered the alarm.*LED status will be cleared when the ignition is turned ON. For proper memoryclearing, insure to connect the alarm ignition input to the ignition on the vehicle.If an output from the alarm is shorted the siren will chirp 4 times and the parklights will flash 4 times when the system is armed or disarmed. The LED will flasha diagnostic code that represents the circuit that is at fault. (See Chart Below).Turning the ignition to the on then off position will reset the diagnostic code.SYSTEM PROGRAMMING - Menu 1PAGE 11 450 SERIESOWNER'S MANUALDIAGNOSTICS |
Related manuals for Ultra Start 450 SERIES
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine