Unipulse F331 Operation Manual

Contents

Unipulse F331 Operation Manual Manual pdf 21 page image

123 SETTING METHOD12SETTING METHODChapter33-3. List of setting values■Comparison setting■Operation setting■Calibration settingItem Initial value Setting range PageHH limit +9999 -9999 to +9999 P. 16HI limit +0750 -9999 to +9999 P. 16LO limit +0250 -9999 to +9999 P. 16LL limit -9999 -9999 to +9999 P. 16Hysteresis 0000 0000 to 9999 P. 17Digital offset 0000 -9999 to +9999 P. 18Near zero 0000 0000 to 9999 P. 18Comparison timing 0: Always 0: Always, 1: NZ,2: Hold/Judge, 3: NZ+Hold/Judge P. 18Item Initial value Setting range PageMoving average filter 1 1 to 512 [times] P. 18Digital low-pass filter 2: 12 0: 3, 1: 6, 2: 12 [Hz] P. 18Hold mode 0: OFF 0: OFF, 1: Sample, 2: Peak,3: Valley, 4: P-P P. 19ZERO key valid/invalid 0: Valid 0: Valid, 1: Invalid P. 21Display frequency 2: 20 0: 5, 1: 10, 2: 20 [times/sec.] P. 21Externaloutput selectionOutput selection 1 3: HI 0: OK, 1: NG, 2: HH, 3: HI, 4: LO, 5: LL P. 23Output selection 2 4: LO 0: OK, 1: NG, 2: HH, 3: HI, 4: LO, 5: LLItem Initial value Setting range PageZero calibration 0.000 -3.000 to 3.000 [mV/V] P. 14Equivalent input calibration (rated output) 3.000 0.500 to 3.000 [mV/V] P. 14Actual load calibration (capacity) 1000 0001 to 9999 P. 14Decimal place 2: 0.00 0: None, 1: 0.0, 2: 0.00, 3: 0.000 P. 15Indicator ID All 20H 20H to 60H, 7BH to 7EH20 bytes of ASCII code P. 15Loadcell ID All 20H 20H to 60H, 7BH to 7EH20 bytes of ASCII code P. 15