Unitech MS250 User Manual
                                                                      | |
Contents
| 
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.50To setup same code delay reading interval:1.Scan the "Begin" label2.Go the Decimal Value Tables in Appendix A, Scan label(s),that represents the samecode delay reading interval. They are ranged form 1-50.One step is represented0.1second.So the interval is from 0.1 to 5 seconds.3.Scan the "Complete" label4. Repeat the steps 1-3 to set time out of same symbolBeginDecimal Value (1-50) (Appendix A)Complete7.7 Reverse Output Characters<Disable>Enable7.8 Setup DeletionTo setup the deletion of output characters:1. Scan the label of the desired set below.2. Scan the label of the desired symbology.3. Go to the Decimal Value Tables listed in Appendix A, scan labels that representsthe desired position to be deleted.4. Scan "Complete" label of "Character Position to be Deleted".5. Go to the Decimal Value Tables in appendix A,scan labels that represents thedesired position to be deleted.6. Scan the "Complete" label of "Number Position to be Deleted".7. Repeat the steps 1 – 6 to set additional deletion. |
Related manuals for Unitech MS250
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine