Unitech MS250 User Manual
                                                                      | |
Contents
| 
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.43.2 Loop of ProgrammingThe philosophy of programming parameters has been shown on the flow chart of 2.1.Basically user should1. Scan Start of Configuration.2. Scan all necessary labels for parameters that meet applications.3. Scan End of Configuration to end the programming.4. To permanently save the settings you programmed, just scan label for SaveParameters.To go back to the Default Settings, just scan label for Set All Defaults.3.3 Factory Default SettingsThe factory default settings are shown with <> and bold in the following sections. Youcan make your own settings by following the procedures in this manual. If you want tosave the settings permanently, you should scan the label of “Save Parameters“ inchapter 2.4,otherwise the settings will not be saved after the decoder power is off,and all settings will go back to previous settings.By scanning “Set All Default“ label, the settings will go back to the factory defaultsettings.3.4 Main Page of ConfigurationSet AII DefaultsStart ConfigurationEnd ConfigurationAbort ConfigurationVersion Information |
Related manuals for Unitech MS250
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine