Unitech MS912+ Quick Manual

Also see for MS912+: User manual Quick guide Quick start guide User manual

Contents

- 23 - - 24 -AUTO MODEBATCH MODEThe following pages only apply to the batch versionmini wireless scanner, MS912M+ (P/N: MS912-FUBB00-SG/TG), which can be easily distinguishedby an “M” mark on the rear of the scanner.Being out of range, the scanner will temporarilykeep scanned data in its memory buffer(2K RAM)until the buffer is full. The scanner will send allstored data back to the host after getting in range.*Note: Auto Mode will not function when BatchMode is enabled, or no connection is made beforehand.Once enabled, a checksum will be added to the end of each datato conduct Xor calculation. For Bluetooth SPP & USB-VCP, the BCCis 1 byte. For Bluetooth HID, the BCC are 2 bytes.Example:The barcode data is “TEST” with terminator 1. Bluetooth SPP & USB-VCP:Data Format = + + ~~+ + + + .~~BCC = 54h ^ 45h ^ 53h ^ 54h ^ 0Dh ^ 0Ah = 11h2. Bluetooth HID:Data Format = + + ~~+ + +~~ BCC = 54h ^ 45h ^ 53h ^ 54h ^ E7h = F1hHowever, since control character cannot be displayed inBluetooth HID, BCC will be converted into 2 bytes of characters.As a result, the data will be: TEST + + F + 1BINARY CHECK CHARACTER. E030$*.e030$*. E029$*.e029$* DISABLEENABLEFor MS912M+ onlyFor MS912M+ only