Unitech MS916 User Manual
Also see for MS916: User manualQuick start guideUser manualQuick start guideQuick start guide
                                                                                   | |
Contents
| 
- 33 -Time-out Between Same SymbolParameter # 0x89When in Continuous triggering mode, this parameter sets the minimum timethat must elapse before the scan engine decodes a second bar code identicalto one just decoded. This reduces the risk of accidently scanning the samesymbol twice. It is programmable in 0.1 second increments from 0.0 to 9.9seconds.To set a time-out between same symbol, scan the bar code below. Next scantwo numeric bar codes beginning on page 77 that correspond to the desiredtime-out. Single digit values must have a leading zero. For example, to set atime-out of 0.5 seconds, scan the bar code below, then scan the “0” and “5” barcodes. To change the selection or cancel an incorrect entry, scan Cancel onpage 78.Beep After Good DecodeParameter # 0x38Scan this symbol to set the scan engine to beep after a good decode. |
Related manuals for Unitech MS916
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine