ENGLISHRELEASE FROM INSIDETo release the automation: just pull the doorknob downwards.m WARNING: do not use the doorknob equipped with astring to open the door. It is forbidden hanging objects to therelease string.2.5 For sectional and spring doors onlyFasten the draft small square I on the door upper partby following the previous reference points.Join the draft small square I and the drilled bar L bymeans of the special curved arm M through 2 bolts V4,1 bolt V8 and 3 nuts D2.Join the drilled bar L to the draft truck C by means of ascrew V5 and a nut D3.2.4 Following the reference points, which have been previouslytraced on the ceiling, identify the fastening points forsupports E or bracket P, then drill and using plugssuitable to the ceiling (ø min. 8 mm) fasten the automation.m WARNING: follow the measurements listed in theparagraph “USE LIMITS” page 19.IT IS FORBIDDEN hanging objects or weights to the section ormotor.2.6 For counterweight balanced doors onlyFasten the sliding arm J4 on the door upper part byfollowing the previous reference points.The two anchor plates (upper and lower) of the adapterarm J4 must be on the same line, otherwise addthickness.Join the drilled bar L to the drilled bar of the arm bymeans of 2 bolts V4 and 2 nuts D2.Join the drilled bar L to the draft truck C by means of ascrew V5 and a nut D3.m WARNING: release the draft truck and control that slideeasily along the whole guide.Remove any friction before installing.24
