VALMETAL H Series Operator's Manual And Parts Book
                                                                                      | |
Contents
| 
6. Install only a drawbar pin (Fig 8 "B") that hasprovisions for a mechanical retainer such as aKlik pin.7. Install the retainer.8. Attach the safety chain (C) around the drawbarcage and clip securely in position.9. Be sure the tractor is equipped with 1 3/8 inch 6spline shaft.10. Check that the driveline telescopes easily andthat the shield rotates freely.11. Depress the lock pins on the yoke and slide theyoke over the shaft until the lock pins click inposition.12. Attach the hydraulic lines to the tractor:a. Use a clean rag or paper towel to clean thedirt from the couplers on the tractor andthe hose ends.b. Insert the hose ends into the tractorcouplers. Be sure they are securelyseated.c. Route and secure the hoses over the hitchto prevent binding and pinching. Do notallow the hoses to contact moving parts.13. Raise the jack to its highest position. Removepin through the mount. Remove jack and stowaway in front of machine as shown in figure 10,page 20. Then repin and install the retainer.14. Install the light bar on the rear of the frame iftransporting.15. Reverse the above procedure when unhookingfrom the tractor. Place planks under the jack forextra support if required.OPERATION20AFig. 7 JACKFig. 8 DRAWBAR PINBFig. 9 SAFETY CHAINCWARNINGUse extreme care when working around a high-pressure hydraulic system. Make sure all connec-tions are tight and all components are in goodrepair. Wear hand and eye protection whensearching for suspected leaks. |
manualsdatabase
Your AI-powered manual search engine