VDO CD 4203 User Manual

Also see for CD 4203 -: Datasheet

11EnglishMAIN FUNCTIONSSwitching On/OffPress POWER to switch the set ON or OFF.Selecting a sourceYour car radio is designed for different types ofsources You can select them by a short presson the SOURCE key.Press the SOURCE key to display and select thesource you want to play.- Tuner (radio),- CD/MP3,- CD Changer (CDC),- Auxiliary.Controlling the volumea-VolumeUse the keys +/- to adjust the volume: thevolume automatically increases or decreases ifthe SDVC connection has been installed andselected (see Installation in page 6).Note : Make sure that you can always hear thetraffic (horns, sirens, etc.).b-Mute1- Press MUTE, to mute the audio system.2- Press MUTE again if you want to restorethe last audio source heard.Note 1 : In this state, the following audibleevents can occur: Announcements (Traffic,News, Navigation), Telephone calls, Alarms.Note 2 : Some cars, mobile phones or navi-gation system can automatically interrupt theaudio output if they are linked to the set.c-Wake upIf your mobile phone is connected to the carradio (see Connector D1 in page 7), you willnot miss any incoming call even when the carradio is switched Off because it willautomatically "wake up" upon detecting a call.Displaying Source InformationsShort press on the DISPLAY key to displayinformations (track, time, info line, etc.) aboutthe chosen source (Tuner, CD/MP3,CDC).SAM MENUThe SAM menu allows you to configure themain options of your car radio.1- Long press the MUTE key to get to the SAMMENU (see options in cover pages).2- Use the keys to select an option.3- Use the keys to set the option value.4- Press ESC to enter the value.Defining the Scan TimeWith this function, you can define the timebefore jumping to the next station (Tuner) ortrack (CD/MP3,CDC).1- Long press MUTE.2- Select SCAN TIME using the keys.3- Use the keys, to select a number ofseconds (10s by default).4- Press ESC to enter the value.Using radio when not runningThis function allows the use of the car radiowhen the vehicle is not running (only if the A7wire is connected to a permanent supply).1- Long press MUTE.2- Select LOGIC with the keys.3- Use the keys, to select ON (default value)or OFF.4- Press ESC to enter the value.Note : The set will turn OFF after 1 hour or ifthe battery voltage becomes < 9 volts.Setting an Auxiliary EquipmentThis function enables or disables an auxiliarydevice connected to the set.1- Long press MUTE.2- Select AUXILIARY using the keys.3- Use the keys, to select ON (default value)or OFF.4- Press ESC to enter the value.