VDO CD 4203 User Manual

Also see for CD 4203 -: Datasheet

13EnglishSetting Navigation Detect LevelThis function allows to configure the naviga-tion message detection level (Nav mute wire).1- Long press MUTE.2- Select NAV LVL with the keys.3- Use the keys, to select LOW (defaultvalue) or HIGH.4- Press ESC to enter the value.Note : You need to select the value accordingto the type of the connected equipment.Setting the SDVCSDVC automatically adjust the volumeaccording to the speed of the car. You canswitch off this function or select one of the fivecurves that suit your car. Level 1 gives a smallerincrease while level 5 gives a greater increase.1- Long press MUTE.2- Select SDVC TYPE with the keys.3- Use the keys, to set Off, curve 1, curve 2,curve 3, curve 4 or curve 5.4- Press ESC to enter the value.Note 1: You can use this function only whenthe speed signal is connected and calibrated(see SDVC and Calibrating the speed in pages6 and 10 respectively).Note 2 : You choose a SDVC curve accordingto the state of your environment noise.Launching Loudspeakers InstallationUse this function to verify the installation ofyour loudspeakers.1- Short press ENTER.2- Select INSTALL with the keys.3- Press ENTER to launch the function: a beepis emitted for each well installedloudspeaker.4- Switch OFF/ON the set.Setting the Light Display BrightnessThis source independent function adjusts thebrightness of light display between its min. andmax. value (1 to 10).1- Long press MUTE.2- Select BRIGHTNESS with the arrows .3- Use the arrows to select a value.4- Press ESC to enter the value.TUNERYou can set the radio stations options afterselecting the tuner source. Then by either ashort or long press on ENTER, you get twodifferent tuner menus (see cover pages).Search Left/Search RightUse the keys to scroll through the selec-ted waveband.Search Up/Search DownUse the keys to scroll through the memo-rised stations list of the waveband.TUNER MENU1- Press the SOURCE key to select TUNER2- Short press ENTER to get to TUNER MENU.3- Use the keys, to select an option.4- Use the keys to set the option value.5- Press ESC to enter the value.Selecting a wavebandWith this function, you can select a band in ascrolling list.1- Short press ENTER.2- Select BAND with the keys.3- Select the stations memorised in the presetswith the keys:- FM AST Automatically stored FMstations list- FM 1,2,3. Manual presets FM- FM memo RDS alphabetical list- LW Manual presets LM- MW AST Automatically storedMW stations list- MW 1,2,3. Manual presets MW4- Press ESC to enter the value.Note : The stations in FM memo are onlystations created and updated by RDS memo.