Vacon NX series Operating Manual
Also see for NX series: User manualUser manualApplications manualMaintenance manualApplications manual
               | |
Parameters vacon • 724-hour support +358 (0)201 212 575 • Email: service@vacon.com22. PARAMETERS2.1 Source side parameters2.1.1 Basic parametersP2.1.1 S OURCE NOM CURRENT ID113This parameter defines the current value that is used as the 100 % current for e.g. charging currentlimit.P2.1.2 S OURCE NOM VOLTAGE ID110This parameter defines the absolute voltage value that is used as the 100 % voltage for e.g. thevoltage reference.P2.1.3 S OURCE NOM P OWER ID116This parameter is used for scaling the percentage power monitoring value.P2.1.4 C ONTROL MODE ID1858This parameter is used to select the control mode of the drive.0 = Current control mode1 = Voltage control modeP2.1.5 I DENTIFICATION ID631This parameter is used to calibrate the current measurement.0 = No Action1 = Current measurement offsetWhen the identification is finished, the drive must be connected to the battery system or the usedDC power source. There should also not be any load on the DC-link.Select the identification run and give the DC/DC converter a start command within 20 seconds afterthe identification mode is selected.Table 1. Basic parametersCode Parameter Min Max Unit Default ID NoteP2.1.1 Source Nom Current 0.0 Varies A Varies 113 Capacity of supplyP2.1.2 Source Nom Voltage 200 1099 V Varies 110P2.1.3 Source Nom Power 0 32000 kW 0 116P2.1.4 Control Mode 0 1 0 1858 0 = Current1 = VoltageP2.1.5 Identification 0 1 0 631 0 = No Action1 = Current, Meas, Offset |
Related manuals for Vacon NX series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine