9vacon • 74 CONTROL KEYPADTel. +358 (0) 201 2121 • Fax +358 (0)201 212 2059.3.1 Monitoring menu (M1)You can enter the Monitoring menu from the Main menu by pushing theMenu button right whenthe location indication M1 is visible on the first line of the display. How to browse through themonitored values is presented in Figure 45.The monitored signals carry the indication V#.# and they are listed in Table 24. The values areupdated once every 0.3 seconds.This menu is meant only for signal checking. The values cannot be altered here. For changingvalues of parameters see Chapter 9.3.2.Figure 45. Monitoring menuTable 24. Monitored signalsCode Signal name Unit DescriptionV1.1 Output frequency Hz Frequency to the motorV1.2 Frequency reference HzV1.3 Motor speed rpm Calculated motor speedV1.4 Motor current A Measured motor currentV1.5 Motor torque % Calculated motor shaft torqueV1.6 Motor power % Calculated motor shaft powerV1.7 Motor voltage V Calculated motor voltageV1.8 DC-link voltage V Measured DC-link voltageV1.9 Unit temperature ºC Heat sink temperatureV1.10 Motor temperature % Calculated motor temperature. See All in One applicationmanualV1.11 Voltage input V AI1V1.12 Current input mA AI2V1.13 DIN1, DIN2, DIN3 Digital input statusesV1.14 DIN4, DIN5, DIN6 Digital input statusesV1.15 DO1, RO1, RO2 Digital and relay output statusesV1V14READYLocal13.95 HzREAD YLocal13.95 HzR EADYLo ca lRU N RU NRUNMonitor Output frequencyFreqReference11528_uk
