7Console InstallationMounting the ConsoleFigure 3 illustrates recommended console mounting. Install the console fastening devices to the mounting surfaceusing the hole pattern (6.7” x 5.7”) shown in Figure 4. Mounting screws up to 3/16” diameter may be used.Install metal conduit (1/2” I.P.S.) between the console and the power panel. Figure 4 shows the three designatedknockouts (one each on top, left side, and bottom) through which power wiring can safely enter the console.Figure 3. Recommended Mounting of Consoleconsoles\tls-50\50mnt.eps1500 mm(Maximum)1000 mm(Maximum)1000 mm(Maximum)One 5 ampere fused, switched, neonindication spur (for 240 Vac), or a dedicatedcircuit breaker rated for 15 amperes, 120 Vacor 240 Vac. NOTE, circuit breaker must bemarked as the power disconnect for the console.From an independent 24 hour supply at the distributionpanel, run three 2.5 mm (minimum) standard color codedwires; live, neutral, and earth, to the fused spur. Run one4 mm wire, color coded green/yellow, from the earth busbar at the distribution panel direct to the console location.Leave at least 1 metre of free cable for connection to theconsole.To an external alarm (i.e., Forecourt Alarm)-One 2 ampere fused, switched, neon indicationspur or a dedicated circuit breaker ratedfor 120 Vac or 240 Vac. NOTE, circuit breakermust be marked as the external alarmdisconnect for the console.CommunicationcableConduit for probefield cablesTLS-50ALL FUNCTIONS NORMALT1 VOL: 9889 GAL
