Installation VaporTEK Controller and VaporTEK Interface212. Mount the VaporTEK Interface board to the new sheet metal bracket 900852-001 with the 4 stand offs(579080-001) from the kit (Figure 9).Figure 9. Mount The VaporTEK Interface To The Back Side Of The Support Backet3. Attach VaporTEK Controller/Interface sheet metal bracket 900852-001 to the dispenser with M6 socket headbolt and M6 nut (Figure 9).4. Plug the VaporTEK motor and sensor connectors to the VaporTEK Controller board (Figure 7).5. Attach the motor ground wire to the sheet metal bracket with M3 screw (579158-001) included in the kit(Figure 7).6. Plug the RJ12 cable socket to the VaporTEK Controller (Figure 7).7. Attach the 900651-001 input power cables to the VaporTEK Controller (Black: phase; White: Neutral; Green-Yellow: Ground) and attach the Green-Yellow ground wire with the ring terminal to the sheet metal bracketwith M3 screw (579158-001). The other end of the cable should be connected to the 230V power source(Figure 7).8. Plug the 24V cable with connector to the VaporTEK Interface board (Figure 9).9. Plug the Pulse Side B cables with connector to the VaporTEK Interface (Figure 9).10. Plug the Pulse Side A cables with connector to the VaporTEK Interface (Figure 9).11. Plug the RJ12 cable socket to the VaporTEK Interface (Figure 9).2338 91011
