Vega VEGABAR 82 Quick Setup Manual

Also see for VEGABAR 82: Product information Operating instructions Quick setup guide Operating instructions Operating instructions

Contents

94 Connecting to power supplyVEGABAR 82 • Slave sensor for electronic differential pressure48051-EN-1904044 Connecting to power supply4.1 ConnectingThe connection to the Master sensor is carried out through spring-loaded terminals in the respective housing. For this, use the supplied,confectioned cable. Solid cores as well as flexible cores with cableend sleeves are inserted directly into the terminal openings.In case of flexible cores without end sleeves, press the terminal fromabove with a small screwdriver, the terminal opening is then free.When the screwdriver is released, the terminal closes again.Information:The terminal block is pluggable and can be removed from theelectronics. To do this, lift the terminal block with a small screwdriverand pull it out. When reinserting the terminal block, you should hear itsnap in.You can find further information on the max. wire cross-section under"Technical data - Electromechanical data".Proceed as follows:1. Unscrew the housing lid2. Loosen compression nut of the cable gland and remove blindplug3. Remove approx. 10 cm (4 in) of the cable mantle, strip approx.1 cm (0.4 in) insulation from the individual wires or use suppliedconnection cable4. Insert the cable into the sensor through the cable entryFig. 3: Connection steps 5 and 65. Insert the wire ends into the terminals according to the wiring plan6. Check the hold of the wires in the terminals by lightly pulling onthemConnection technologyConnection procedure