236 Set up with the display and adjustment module PLICSCOMVEGACAL 65 • Foundation Fieldbus30035-EN-1309176 Set up with the display and adjustmentmodule PLICSCOM6.1 Short descriptionThe display and adjustment module is used for measured valuedisplay, adjustment and diagnosis. It can be mounted in the followinghousing versions and instruments:• All sensors of the plics® instrument family, in the single as well asin the double chamber housing (optionally in the electronics orconnection compartment)• External display and adjustment unit VEGADIS 61From a hardware version …- 01 or higher of PLICSCOM as well as ahardware version …- 01, 03 or higher of the corresponding sensor, anintegrated backlight can be switched on via the adjustment menu. Thehardware version is stated on the type label of the PLICSCOM or thesensor electronics.Note:You can find detailed information on the adjustment in the operatinginstructions manual "Display and adjustment module".6.2 Insert display and adjustment moduleThe display and adjustment module can be inserted into the sensorand removed again at any time. It is not necessary to interrupt thepower supply.Proceed as follows:1. Unscrew the housing cover2. Place the display and adjustment module in the desired positionon the electronics (you can choose any one of four different posi-tions - each displaced by 90°)3. Press the display and adjustment module onto the electronicsand turn it to the right until it snaps in.4. Screw housing cover with inspection window tightly back onRemoval is carried out in reverse order.The display and adjustment module is powered by the sensor, an ad-ditional connection is not necessary.Function/ConfigurationMount/Dismount displayand adjustment module