Vega VEGAFLEX 82 Operating Instructions Manual

Also see for VEGAFLEX 82: Safety manual Supplementary instructions Quick setup guide Operating instructions Operating instructions

Contents

Vega VEGAFLEX 82 Operating Instructions Manual Manual pdf 62 page image

6210 Diagnostics and servicingVEGAFLEX 82 • 4 … 20 mA/HART - two-wire44222-EN-170220The following table shows the error codes and text messages in thestatus message "Out of specification" and provides information oncauses as well as corrective measures.CodeText messageReason Rectification DevSpecState in CMD 48S601Overfilling• Level echo in the close range notavailable • Reduce level• 100 % adjustment: Increase value• Check mounting socket• Remove possible interferingsignals in the close range• Use coaxial probeBit 9 ofByte 14 … 24The following table shows the error codes and text messages in thestatus message "Maintenance" and provides information on causesas well as corrective measures.CodeText messageReason Rectification DevSpec Statein CMD 48M500Error in the deliv-ery status• The data could not be restoredduring the reset to delivery status • Repeat reset• Load XML file with sensor datainto the sensorBit 0 ofByte 14 … 24M501Error in thenon-active line-arisation table• Index markers are not continu-ously rising, for example illogicalvalue pairs• Check linearisation table• Delete table/Create newBit 1 ofByte 14 … 24M504Error at a deviceinterface• Hardware defect • Exchanging the electronics• Send instrument for repairBit 4 ofByte 14 … 24M506Installation/Set-up error• Error during setup • Check and correct mounting and/or parameter adjustment• Check probe lengthBit 6 ofByte 14 … 24M507Error in the in-strument settings• Error during setup• Error when carrying out a reset• False signal suppression faulty• Carry out reset and repeat setup Bit 7 ofByte 14 … 2410.4 Rectify faultsThe operator of the system is responsible for taking suitable meas-ures to rectify faults.The first measures are:• Evaluation of fault messages via the adjustment device• Checking the output signal• Treatment of measurement errorsFurther comprehensive diagnostics options are available with a PCwith PACTware and the suitable DTM. In many cases, the reasons canbe determined in this way and faults rectified.Out of specificationMaintenanceReaction when malfunc-tion occursProcedure for fault recti-fication