Vega VEGAMET 624 Supplementary Instructions Manual
Also see for VEGAMET 391: Operating instructionsOperating instructionsOperating instructionsOperating instructionsOperating instructions
                                                                | |
Contents
| 
5711 Measured value transmission via SMSRS232/Ethernet connection • VEGAMET 391/624/625, VEGASCAN 693, PLICSRADIO C6230325-EN-13070111 Measured value transmission via SMS11.1 General informationSending an SMS is only possible with signal conditioning instrumentswith serial interface in conjunction with modems supported by VEGA.A GSM modem and a conventional telephone network modem areavailable for the analogue telephone connection. To send an SMS,the signal conditioning instrument dials into an SMS Service Center(SMSC): Via this SMS Service Center the SMS is the transferred tothe subscriber (e.g. mobile phone).Note:To set up the SMS function, PACTware with the corresponding DTMsis required.11.2 Settings for SMS transmissionOpen the suitable DTM in PACTware and select the menu item"Device settings - SMS" for configuration of the SMS function. Asbasic setting, the connected modem and the requested SMS provider(SMSC) are selected.If the SMS should be transmitted via the conventional telecommuni-cation network, you will need an analogue telephone connection withdirect outward dialing and the Phoenix Contact PSI data/fax modem(order no.: MODEM.JX)If transmission is made via GSM, the Siemens TC35i GSM cellularphone modem must be used (order no.: MODEM.FX). For this youwill need a GSM contract. Make sure that there is sufficient networkcoverage by the provider. Furthermore the PIN of the used SIM cardmust be deactivated.From the provided list you can select the suitable provider (SMSC). Ifthe requested provider is not listed, you can select "User-defined" andenter the respective phone number (only Siemens TC35i) in the field"SMSC phone number". With Poenix Contact PSI Data/Fax Modemyou can only use the providers available in the list.In this field, the phone number of the provider selected previouslyfrom the list appears. After having selected "User-defined" you canenter the phone number of the requested provider.Further SMS settings are carried out under the menu item "Event list".These are:• "Phone number:" Phone number of the SMS addressee• "Event type:" Time, measured value or status-controlled• "Contents of messages:" Measured value or status• "Actuator for transmission:" Time, interval, exceeding/underrun-ning the measured valueModemProviderSMSC phone numberSMS configuration as-sistent |
Related manuals for Vega VEGAMET 391
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine