Vega VEGAPULS 61 Operating Instructions Manual

Also see for VEGAPULS 61: Operating instructions Quick setup guide Operating instructions Operating instructions Quick setup guide

Contents

Vega VEGAPULS 61 Operating Instructions Manual Manual pdf 60 page image

608 Diagnosis, asset management and serviceVEGAPULS 61 • Modbus and Levelmaster protocol41361-EN-160224Further echo curves: Up to 10 echo curves can be stored in a ringbuffer in this memory section. Further echo curves are stored via:• PC with PACTware/DTM• Control system with EDD8.3 Asset Management functionThe instrument features self-monitoring and diagnostics according toNE 107 and VDI/VDE 2650. In addition to the status messages in thefollowing tables, detailed error messages are available under menuitem "Diagnostics" via the display and adjustment module, PACTware/DTM and EDD.The status messages are divided into the following categories:• Failure• Function check• Out of specification• Maintenance requirementand explained by pictographs:41 2 3Fig. 35: Pictographs of the status messages1 Failure - red2 Out of specification - yellow3 Function check - orange4 Maintenance - blueFailure: Due to a malfunction in the instrument, a failure message isoutputted.This status message is always active. It cannot be deactivated by theuser.Function check: The instrument is in operation, the measured valueis temporarily invalid (for example during simulation).This status message is inactive by default. It can be activated by theuser via PACTware/DTM or EDD.Out of specification: The measured value is unstable because theinstrument specification is exceeded (e.g. electronics temperature).This status message is inactive by default. It can be activated by theuser via PACTware/DTM or EDD.Maintenance: Due to external influences, the instrument functionis limited. The measurement is affected, but the measured value isstill valid. Plan in maintenance for the instrument because a failure isexpected in the near future (e.g. due to buildup).This status message is inactive by default. It can be activated by theuser via PACTware/DTM or EDD.Status messages