23GM 4100ACB_02261xB_02264AB CDOPERATING MANUALEDITION 12/2008 PART NO. DOC3948215.4.4 CLEANING AIRCOAT NOZZLEFor disassembly and assembly of AirCoat nozzles see chapter 5.4.3.The AirCoat nozzle (C) can be placed into a cleaning solvent which has been recommend-ed by the paint manufacturer.5.4.5 ELIMINATE NOZZLE CLOGGING1. Relieve spray gun and unit pressure.2. Secure gun with trigger safety catch.3. Unscrew the union nut with nozzle guard (A).4. Remove air cap (B).5. Pull out the clogged nozzle (C) from the air cap (B), reverse it and replace it into nozzleseal (D).6. Refit air cap (B) on the nozzle (C), ensuring that the location flats (X) are in line.7. Fit the union nut with nozzle guard (A) over the air cap (B) onto the spray gun andtighten by hand.8. Switch the material pressure back on.9. Turn the safety catch to the spraying position and briefly pull trigger.10. When the blockage has been flushed out secure the gun with safety catch.11. Relieve spray gun and unit pressure12. Unscrew the union nut with nozzle guard (A).13. Remove air cap (B) and reverse nozzle (C) again. Clean nozzle and replace on the nozzleseal (D) in spray position.14. Refit air cap (B) on the nozzle (C), ensuring that the location flats (X) are in line.15. Fit the union nut with nozzle guard (A) over the air cap (B) onto the spray gun andtighten by hand.16. Switch the material pressure and the air pressure back on.Nozzle in „spray“ positionNozzle in „cleaning“ position