WAGNER ProSpray 3.25 Operating Manual

32 ProSpray 3.25GB4QSBZJOHUFDIOJRVF )BOEMJOHUIFIJHIQSFTTVSFIPTF5. Spraying techniqueInjection hazard. Do not spray without the tip guardin place. NEVER trigger the gun unless the tip iscompletely turned to either the spray or the unclogposition. ALWAYS engage the gun trigger lockbefore removing, replacing or cleaning tip.The key to a good paint job is an even coating over the entire surface.Keep your arm moving at a constant speed and keep the spray gun ata constant distance from the surface. The best spraying distance is 25to 30 cm between the spray tip and the surface.25 - 30 cmKeep the spray gun at right angles to the surface. This means movingZPVSFOUJSFBSNCBDLBOEGPSUISBUIFSUIBOKVTUóFYJOHZPVSXSJTUKeep the spray gun perpendicular to the surface, otherwise one endof the pattern will be thicker than the other.Trigger gun after starting the stroke. Release the trigger beforeending the stroke. The spray gun should be moving when the triggerJTQVMMFEBOESFMFBTFE0WFSMBQFBDITUSPLFCZBCPVU5IJTXJMMensure an even coating.25 - 30 cm25 - 30 cmi If very sharp edges result or if there are streaks in thespray jet – increase the operating pressure or dilutethe coating material.6. Handling the high-pressure hose5IFVOJUJTFRVJQQFEXJUIBIJHIQSFTTVSFIPTFTQFDJBMMZTVJUFEGPSpiston pumps.Danger of injury through leaking high-pressurehose. Replace any damaged high-pressure hoseimmediately.Never repair defective high-pressure hoses yourself!The high-pressure hose is to be handled with care. Avoid sharpbends and folds: the smallest bending radius is about 20 cm.Do not drive over the high-pressure hose. Protect against sharpobjects and edges./FWFSQVMMPOUIFIJHIQSFTTVSFIPTFUPNPWFUIFEFWJDF.BLFTVSFUIBUUIFIJHIQSFTTVSFIPTFDBOOPUUXJTU5IJTDBOCFavoided by using a Wagner spray gun with a swivel joint and a hosesystem.i When using the high-pressure hose while workingon scaffolding, it is best to always guide the hosealong the outside of the scaffolding.i The risk of damage rises with the age of the high-pressure hose. Wagner recommends replacing high-pressure hoses after 6 years.i Use only WAGNER original-high-pressure hoses inorder to ensure functionality, safety and durability.7. Interruption of work 0QFOUIFSFMJFGWBMWF WBMWFQPTJUJPO13*.&(k circulation). 4XJUDIUIFVOJU0''3. Turn the pressure control knob counterclockwise to minimumpressure.4. Pull the trigger of the spray gun in order to release thepressure from the high-pressure hose and spray gun.5. Secure the spray gun, refer to the operating manual of thespray gun.6. If a standard tip is to be cleaned, see Page 39, Section 12.2.If a non-standard tip is installed, proceed according to therelevant operating manual.7. Depending on the model, leave the suction tube or thesuction hose and return hose immersed in the coatingmaterial or swivel or immerse it into a corresponding cleaningagent.AttentionIf fast-drying or two-component coating material isused, ensure that the unit is rinsed with a suitablecleaning agent within the processing time.