WAGNER SPRINT XE Translation Of The Original Operating Manual

Operating manual Manual Powder System SPRINT XE4 Basic Safety Instructions14 Order number 2354920 | Edition 01/20234 For sufficient health and environmental protection, only operate the device withtechnical ventilation (extraction) switched on.4.2.2 Safe Handling of WAGNER Powder Spray DevicesDanger due to dust formation!4 Do not point spray guns at people.4 Do not spray device parts using electrostatic equipment.4 Before any work on the device, in the event of work interruptions and malfunctions:4 Switch off the energy/compressed air supply.4 Relieve pressure on spray gun and device.4 Secure the spray gun against actuation.4 Disconnect the control unit from the mains.4 In the event of functional faults, remedy the fault as described in the chapter ontroubleshooting.4 Carry out the work steps in accordance with the chapter on pressure relief in theoperating manual of the corresponding device:4 If a prompt for pressure relief is given.4 If coating work is interrupted or stopped.4 Before the device is externally cleaned, checked or serviced.4 Before the spray nozzle is installed or cleaned.4.2.3 Grounding the DeviceDanger due to electrostatic charge!Explosion hazard and damage to the device.The electrostatic charge may, in certain cases, give rise to electrostatic charges on the device.Flames or sparks can form during discharge.Correct grounding of the entire coating system prevents electrostatic charges:4 Ensure that all devices and tanks are grounded before each coating process.4 All conductive components of the system, such as floors, walls, ceilings, barriers,transport equipment, work pieces, powder tanks, moving devices or structural parts inthe spray area, with the exception of parts under high voltage during operation, mustbe connected to the grounding system.Parts of the spray booth must be grounded.4 Ensure that all persons inside the working area are grounded, e.g., that they arewearing static dissipative shoes.4 Grounding cables must be checked regularly to ensure that they are serviceable (see EN60204).4.2.4 Product HosesDanger due to damaged product hoses!The product hose may cause dangerous injuries.4 Use only an original WAGNER powder hose.4 Make sure that the hoses are laid only in suitable places. Hoses should not be laid in thefollowing places under any circumstances:4 in high traffic areas