WAGNER SPRINT XE Translation Of The Original Operating Manual

Operating manual Manual Powder System SPRINT XE12 Accessories56 Order number 2354920 | Edition 01/20233. Pull the gun cable out of the socket (A) on the control unit.4. Plug the switchbox's electrical cable (B) into the socket (A) on the control unit andsecure it with the protective sleeve.5. Connect the spray gun to the appropriate connection on the switchbox and secure itwith the protective sleeve of the spray gun cable.6. Set the switch (C) on the switchbox to the desired gun type.12.5.2 Switching the gun typeInfoClean the powder residues from all powder-conveying parts thoroughly, before changingto another gun type.12P_02719P_05053EPG SPRINT X0 %1020304050Ø12101198m /h2.03.00.50.30.11.535.54.53.52.580100 %Tri90607015For example: switching from Corona to Tribo1. Switch off control unit with switch (1) on the rear or with [Standby] button (15) on thefront.2. Change the coating powder from Corona to Tribo.3. Disconnect the hose (2) (transparent, atomizing air) from the Corona gun and connectit to the Tribo gun (Tribo air).4. Disconnect the powder feed hose of the Corona gun from the powder injector andconnect the Tribo gun powder feed hose to the powder injector.5. Set the switch (C) on the switchbox to Tribo.6. Switch on control unit with switch (1) on the rear or with [Standby] button (15) on thefront.InfoParameter C11, in the EPG-Sprint XE control unit device configuration, must be set to[aut]. No gun is selected at first after the control unit is switched on. This will however beautomatically selected and displayed after 1 second.