WAGNER W 350 Operating Instructions Manual

7W 350 AUSsetting.Important: Begin spraying outside of the target area and avoid interruptions inside thetarget area.• Correct (Fig. 7a) Be sure to hold the spray gun at an even distance of approx. 5 - 15 cmto the target object.• Incorrect (Fig. 7b) Heavy spray fog build-up, uneven surface quality.• Move the spray gun evenly cross-wise or up-and-down, depending on the spray patternsetting.12. Taking Out of Operation and CleaningProper cleaning is the prerequisite for problem-free operation of the paint applicationdevice. No warranty claims are accepted in case of improper or no cleaning. Whenprocessing 2-component varnishes, clean the device immediately.1) Turn off the machine and remove the plug. Vent the container in case of longer breaksand after the work has been terminated. This can be done by briefly turning openand then closing the container or by pulling the trigger and letting the paint into theoriginal paint container.2) Divide the spray gun. Press the hook (Fig. 3 "click") slightly downwards. Turn the gunfront part and gun rear part against each other and take them apart.3) Unscrew the container. Empty any remaining coating material back into the materialtin.4) Pull out the suction tube with container seal.CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray gun withmetal objects. The ventilation hose and diaphragm are only solvent-resistantto a limited extent. Do not immerse in solvent, only wipe.5) The unit may only be operated with an integer diaphragm (Fig. 9 A, 15). If anypaint has penetrated to the ventilation hose, check and clean the membrane (see theMaintenance chapter).WARNING! Never hold the spray gun rear part under water or immerse itinto liquids. Clean the housing only with a moistened cloth.6) Unscrew the union nut (Fig. 9, 1) and remove the air cap (2) and nozzle (3). Clean the air cap,nozzle seal (4) and nozzle with a brush and solvent or water. Clean the ventilating bore(Fig. 9, C).AssemblyAttention! Never operate the device if the nozzle seal is either damaged ormissing. If the nozzle seal is either missing or damaged liquids can enterthe device and increase the risk of an electric shock.1) Push the nozzle seal (fig. 9 B, 4) over the needle (18); the groove (slot) should pointtowards you.