WAGO-I/O-SYSTEM 750 XTR Mounting 35750-630/040-001 SSI Interface Adjust XTRManualVersion 1.1.02. Press the I/O module into the assembly until the I/O module snaps into thecarrier rail.Figure 8: Snap the I/O Module into Place (Example)With the I/O module snapped in place, the electrical connections for the datacontacts and power jumper contacts (if any) to the fieldbus coupler/controller orto the previous or possibly subsequent I/O module are established.Pos : 25.12 /Serie 750 ( WAGO-I/O-SYST EM)/Monti eren/D emonti eren/XTR-I/O-Modul entfernen @ 28\mod_1486551166032_21.doc x @ 405491 @ 3 @ 15.2.2 Removing the I/O Module1. Remove the I/O module from the assembly by pulling the release tab.Figure 9: Removing the I/O Module (Example)Electrical connections for data or power jumper contacts are disconnected whenremoving the I/O module.

WAGO 750-630/040-001 Manual

Notes about this Documentation

Symbols

Number Notation

Important Notes

Technical Condition of Specified Devices

Safety Advice (Precautions)

System Description

Manufacturing Number

Component Update

Technical Data

Connection Type

Residential Use

Example Dimensions

Standards and Approvals

Assembly

Mounting onto Carrier Rail

WAGO DIN Rail

Spacing

Mounting Sequence

Inserting and Removing Devices

Inserting the I/O Module

Removing the I/O Module

Connect Devices

Power Contacts/Field Supply

Connecting a Conductor to the CAGE CLAMP

Connecting a Conductor to the Push-in CAGE CLAMP

Power Supply

System Supply

Dimensioning

Field Supply

Fusing

Power Supply for Mixed Operation

Supplementary Power Supply Regulations

Supply Example

Power Supply Units

Grounding

Grounding Function

Shielding

Signal Lines

List of Figures

List of Tables

750-602/040-000

750-630/040-001