WAVECONTROL SMP2 User Manual
Also see for SMP2: User manualUser manualUser manual
                                                                      | |
Contents
| 
P. 62www.wavecontrol.comUser’s ManualElectromagnetic Field MeterAppendix 6. Communication ProtocolThis communication protocol is valid for USB orfibre. The main difference between the two is theport settings.PortsUSB: it emulates a serial port service with CDC,automatically negotiated rate, 8 bits, no parity,1bit stop. The Vendor ID and Product 0x1FC9 ID0x807B of the USB may be used to find the portnumber opened by the driver.Fibre: 230400 bps, 8 bits, no parity, 1 bit stop. The0x0403 Vendor ID and Product ID 0x6001 may beused to find the number of communication portopened by the FTDI driver.Format of commands and responsesCommunication is done through the exchange ofstrings with the XML format. The SMP2 checksthe frames received and rejects them if not wellformed.The XML format accepted by the SMP2 parser isas follows :Command:PC SMP2 General format of commands |
Related manuals for WAVECONTROL SMP2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine