Wacker Neuson BTS 930 Operator's Manual
                                                              | |
Contents
| 
T00823GB 43Cutting attachment in central / side positionNOTE: The Power Cut is delivered with the cuttingattachment mounted in the middle position (1). Forcutting up against obstacles, such as curbs or walls,the cutting attachment can be mounted to one side (2).Use this position only when actually necessary, andafterwards return the cutting attachment to the middleposition. In this position the Power Cut has betterbalance, is easier to guide, and is not as fatiguing forthe operator.Repositioning the cutting attachmentLoosen nuts (5).Loosen the tightening screw (3) (counter-clockwise)until the end of the screw (4) is visible in the gap.Unscrew the nuts (5) and remove the cover (6).Turn the hood lock (8) clockwise as shown in theillustration (to the highest point of the slanted level).NOTE: The slip lock (Fig. 68/ 7) can only be overcomewhen the hood lock (8) is in the position shown.Turn the hood (9) as shown in the illustration.Turn the hood lock (8) to the starting postion and lockthe hood by turning it slightly (the hood lock will catchaudibly).Disengage the V-belt (10) and remove the cuttingattachment.Press the cutting attachment (11) in the side positiononto the drive arm attachment.Guide the V-belt (10) over the V-belt wheel (12).67686970 |
Related manuals for Wacker Neuson BTS 1030
manualsdatabase
Your AI-powered manual search engine