Wacker Neuson G 25 Operator's Manual

Also see for G 25: Operator's manual Operator's manual

Contents

Wacker Neuson G 25 Operator's Manual Manual pdf 40 page image

Operation G 25wc_tx000137gb.fm 402.20 Manual Start-upSee Graphic: wc_gr001682, wc_gr001677, wc_gr001683Before starting the generator set, thoroughly review the pre-start-upchecklist in the previous section. Proceed with generator start-up onlyafter checking each item in that section.Thoroughly read and make sure you understand the engine Operator’sManual supplied with the generator. Follow the steps below and theillustration on the opposite page in the order listed.When using the generator as a standby or substitute power supply,make sure the voltage and phase rotation of the line connectionsmatch those of the utility lines or of any other power source normallyused. Failure to match phase rotation and voltage may causeequipment connected to the generator to operate incorrectly!This could create unsafe operating conditions.2.20.1 Check position of Voltage Selector Switch and make sure it is set forthe desired voltage output. Lock the switch in place.2.20.2 Make sure the Engine Start Switch (f) is in the off “O” position.2.20.3 Turn main line circuit breaker (a) and convenience receptacle circuitbreakers to off “O”. This will disconnect all loads from the generator.2.20.4 Move Engine Start Switch (f) to “REMOTE START” to check operationof engine control module. The LCD panel should momentarily display“SYSTEM OK” followed by “UNIT IN AUTO” and engine information.Check fuel level and battery values.Note: The amber Warning Light (d) will come on if the fuel level isbelow 25%, or engine temperature is below 70°F. This will not preventthe engine from starting.2.20.5 Press in the Emergency Stop Button (p). The LCD panel should read“EMERGENCY STOP”. Release the stop button after verifying thedisplay and return the Engine Start Switch to off “O”.2.20.6 Start engine by moving the Engine Start Switch to the “START/RUN”position.After displaying “GLOW PLUG ON” sequence, the LCD display willread “STARTING ENGINE” as the engine begins its crank cycle. Thenormal cycle is for the engine to crank for 15 seconds, then rest for 10seconds. This cycle will repeat three (3) times. If the engine does notstart within this time, the Engine Control Module will shut down theengine and “FAULT OVERCRANK” will be displayed on the LCDpanel. To repeat crank cycle, return start switch to off “O” to resetEngine Control Module. Allow starter motor to cool between start-upattempts.WARNING