S TARTING UP AND OPERATINGC HAPTER 7THP 94/42 R 4 XXTTHP 125/42 R 4 XXTTHP 140 H/42 R 4 XXT GB-07.2005 7-37.1 Setting up the truck-mounted concrete pumpSelect the location having regard to the safety instructions in section 2.7, and drive the machine to the location.NOTE:Be sure to allow sufficient space for setting up truck-mounted concretepump! Allow additional space for the mixer truck also!On sloping ground put chocks behind the wheels, release the brakes and allow the truck-mounted concretepump to roll back on to the chocks. Then apply the handbrake and extend the outriggers.The ground must be checked for its load-bearing capability.Fully deployed outriggers right:Space requirement at the front: 8,5 m + 0, 6 m = 9,1 mSpace requirement at the rear: 8,0 m + 0, 6 m = 8,6 mSlewing range: 0° - 360°Narrow outriggers one side:Space requirement at the front: 6,1 m + 0, 6 m = 6,7 mSpace requirement at the rear: 5,7 m + 0, 6 m = 6,3 mSlewing range: 0° - 200° oder 360° - 160°Narrow outriggers on both sides:Space requirement at the front: 3,7 m + 0, 6 m = 4,3 mSpace requirement at the rear: 3,4 m + 0, 6 m = 4,0 mSlewing range: 160° - 200°CAUTION: Narrow outriggers may only be used when XXAcontrols are installed and in use!CAUTION: Narrow outriggers may only be used when XXAcontrols are installed and in use!8,5000.6 m for outrigger plates0.6 m for outrigger plates0.6 m for outrigger plates6,1003,7008,0005,7003,400Fig. 7.2 Space requirement for outriggers for the truck-mounted concrete pump
