Sound Parameters – Envelopes127 Waldorf Q User’s ManualLoop AllThe Loop All envelope type is similar to the Loop S1S2 envelope type but it loops through allenvelope stages as long as a note is held. This means that it goes through all envelope stages first andif it ended with the Release phase, the envelope restarts from zero and goes through all its phasesagain. As soon as the note is released, the looping stops and the envelope goes into its Releasephase.Attack DecaySustainReleaseKey pressed Key releasedTimeLevel100%Attack Level Sustain 2Decay 2LoopPicture 43: Loop All EnvelopeAttack 0…127Determines the attack rate or amount of time it takes for a signal to go from zero to Attack level.Attack Level 0…127Controls the level where the Attack phase ends and the Decay phase starts.Decay 0…127Determines the decay rate or amount of time it takes for a signal to reach the Sustain level. Thisphase is also used in the loop to go from Sustain 2 to Sustain.Sustain 0…127As soon as the Sustain level is reached, the envelope proceeds with the second Decay/Sustain pairas explained below.Decay 2 0…127Determines the decay rate or amount of time it takes for a signal to reach the Sustain 2 level.Sustain 2 0…127Sets the second Sustain level. As soon as this level is reached, the envelope goes into the Releasephase.Release 0…127The Release phase is used while the note is pressed to form the last stage before the loop restarts withthe Attack phase. When the note is released, the loop stops and the Release phase is used to fade theenvelope to zero.
