Waldorf RN8200G Installation And Operation Manual

Also see for RN8200G Series: Installation and operation manual Installation and operation manual Installation and operation manual

Contents

Waldorf RN8200G Installation And Operation Manual Manual pdf 12 page image

10Installation RequirementsNOTE:• It is most important that this Cooktop is installed correctly and that operation is correctbefore use. Installation shall comply with local gas, health and safety requirements.• This appliance shall be installed with sufficient ventilation to prevent the occurrence ofunacceptable concentrations of health harmful substances in the room, the appliance isinstalled in.Waldorf Cooktops are designed to provide years of satisfactory service, and correct installation is essentialto achieve the best performance, efficiency and trouble-free operation.This appliance must be installed in accordance with National installation codes and in addition, inaccordance with relevant National / Local codes covering gas and fire safety.AUSTRALIA: - AS5601 - Gas Installations.NEW ZEALAND: - NZS5261 - Gas Installation.UNITED KINGDOM: - Gas Safety (Installation & Use) Regulations 1998.- BS6173 - Installation of Catering Appliances.- BS5440 1 & 2 - Installation Flueing & Ventilation.IRELAND: - IS 820 - Non - Domestic Gas Installations.Installations must be carried out by authorised persons only. Failure to install equipment tothe relevant codes and manufacturer’s specifications shown in this section will void thewarranty.Components having adjustments protected (e.g. paint sealed) by the manufacturer are onlyallowed to be adjusted by an authorised service agent. They are not to be adjusted by theinstallation person.Unpacking• Remove all packaging and transit protection from the appliance including all protective plasticcoating from the exterior stainless steel panels.• Check equipment and parts for damage. Report any damage immediately to the carrier anddistributor.• Report any deficiencies to the distributor who supplied the appliance.• Check that the available gas supply is correct to that shown on the Rating Plate attached to theunderside of the R/H side, front Cooktop lower trim, for Bench, Cabinet Base and Leg Stand Models.For the Refrigerated Base Models the Rating Plate is located inside the right hand front panel andcan be viewed through the upper grille.Location1. Installation must allow for a sufficient flow of fresh air for the combustion air supply.2. Installation must include adequate ventilation means, to prevent dangerous build up of combustionproducts.3. Never directly connect a ventilation system to the appliance flue outlet.4. Position the appliance in its approximate working position.5. All air for burner combustion is supplied from underneath the appliance. The legs must always befitted and no obstructions placed on the underside or around the base of the appliance, asobstructions will cause incorrect operation and / or failure of the appliance.NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system tothe appliance flue outlet.InstallationNatural Gas (G20) 12 m3 /hr 24 m3 /hr 36 m3 /hr 48 m3 /hrLPG/Propane (G31) 13 m3 /hr 25 m3 /hr 38 m3 /hr 50 m3 /hrCombustion Air Requirements:RN8200G RN8400G RN8600G RN8800G