Waldorf RN8200G Installation And Operation Manual

Also see for RN8200G Series: Installation and operation manual Installation and operation manual Installation and operation manual

Contents

Waldorf RN8200G Installation And Operation Manual Manual pdf 21 page image

19GeneralClean the Cooktop regularly. A clean Cooktop looks better, will last longer and will perform better.Carbonised grease on the surface or between the trivets, griddle plates will hinder the transfer ofheat from the cooking surface to the food. This will result in loss of cooking efficiency.NOTE: Each griddle option can be supplied with a scraper tool and a pack of blades for cleaningthe griddle surface. These are not supplied with the griddle and have to be purchasedseparately. Refer to the 'Replacement Parts List' at the rear of this manual.DO NOT use water on the trivets, burners and griddle plates while these items are stillhot as warping and cracking may occur. Allow these items to cool down and thenremove for cleaning. The entire trivets, griddle plates and burner caps can be dismantled forcleaning.NOTE:• DO NOT use abrasive detergents, strong solvents or caustic detergents as they couldcorrode or damage the Cooktop.• In order to prevent the forming of rust on the trivets, griddle plate (If fitted) and burners,ensure that any detergent or cleaning material has been completely removed after eachcleaning. The appliance should be switched on briefly to ensure the griddle plates becomedry. Oil or grease should be spread over the griddle surface in order to form a thinprotective greasy film.To keep your Cooktop clean and operating at peak efficiency, follow the procedures shown below:-After Each Use1. Clean the griddle and cooktop castings with a scraper tool to remove any build up of carbon.2. Always ensure that the scraper tool blades are changed regularly to ensure that the scraper toolworks efficiently and prevents damage to the griddle plate surface.3. Clean the cooktop castings with a stiff nylon brush or a flexible spatula to remove any food debris.4. Clean the Control Panel with a damp cloth lightly moistened with a solution of mild detergent andwater. Dry the control panel thoroughly with a dry cloth and polish with a soft dry cloth.Cleaning and MaintenanceC AUTION :Always turn off the gas supply before cleaning.This appliance is not water proof.Do not use water jet spray to clean interior or exterior of this appliance.WARNING:THE BLADES FITTED TO THE SCRAPER TOOL ARE EXTREMELY SHARP AND ARE TO BE USED WITH CARE .C AUTION :Always ensure that an even pressure is applied over the whole surface of thescraper tool when using on the flat surface of the griddle, to prevent scoring ofthe surface.NEVER bang the sharp edge of the scraper tool on the flat surface of thegriddle as this will damage the griddle and invalidate the warranty.