Waldorf RN8410G Installation And Operation Manual

Also see for 800 SERIES: Operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

Waldorf RN8410G Installation And Operation Manual Manual pdf 10 page image

8InstallationClearancesNOTE: Only non-combustible materials can be used in close proximity to this appliance.* Side clearances can be 50mm when adjacent surface is at least 100mm below cooking surface.AssemblyNOTE: All Models are delivered completely assembled. No further assembly is required. This appliance is fitted with adjustable feet to enable appliance to be positioned securelyand level. This should be carried out on completion of gas connection. Refer to ‘GasConnection’ section.Optional Accessories (Refer to Replacement Parts List) Rear Roller Kit. For installation details, refer to instructions supplied with each kit. Plinth Kit. For installation details, refer to instructions supplied with each kit.1. Check all feet (or castors) are securely fitted.2. Adjust feet to make oven range steady and level.Gas ConnectionNOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON.1. Waldorf Ranges do not require an electrical connection, as they function totally on gas supply only.2. It is essential that gas supply is correct for appliance being installed and that adequate supplypressure and volume are available. The following checks should be made before installation:-a. Gas Type the appliance has been supplied for is shownon coloured stickers located above gas connection andon rating plate. Check that this is correct for the gassupply the appliance is being installed for. Gasconversion procedure is shown in this manual.b. Supply Pressure required for this appliance is shown in‘Specifications’ section of this manual. Check gas supplyto ensure adequate supply pressure exists.c. Input Rate of this appliance is shown on Rating Plateand in ‘Specifications’ section of this manual. Input rateshould be checked against available gas supply linecapacity. Particular note should be taken ifappliance is being added to an existinginstallation.NOTE: It is important that adequately sized piping runs directly to connection joint on appliancewith as few tees and elbows as possible to give maximum supply volume.3. Fit gas regulator supplied, into gas supply line as close to appliance as possible.Combustible Surface Non Combustible SurfaceLeft / Right hand side 250 mm (*) 0 mmRear 100 mm 0 mmFig 1Rating PlateLocation This appliance is for professional use and is only to be used by qualifiedpersons. Only authorised service persons are to carry out installation, servicing or gasconversion operations.Caution