Waldorf RN8410G Installation And Operation Manual

Also see for 800 SERIES: Operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

Waldorf RN8410G Installation And Operation Manual Manual pdf 15 page image

13OperationOven Pilot Ignition1. Open oven door. Depress thermostat control knob androtate anti-clockwise to ‘PILOT’ position.2. With gas control knob depressed, press piezo ignitionbutton to ignite pilot burner. Repeat Items 1 to 2 untilpilot is lit.3. Release gas control knob approximately 10-20 secondsafter lighting pilot, until pilot thermocouple is heated upby pilot flame.4. Pilot should now remain alight. If pilot does not light,repeat Items 1 to 3 above.5. View pilot burner through holes in front of burner boxwith oven door open. See Fig 4.Oven - Main Burner / Thermostat1. With pilot burner alight, rotate thermostat control knob anti-clockwise to desired oven temperaturesetting required, this will regulate gas supply to burner.2. To turn main burner ‘OFF’, simply turn thermostat control knob clockwise to ‘OFF’ position.Turning the Oven to ‘Standby’ (Pilot ‘ON’ Only)1. To turn off oven burner / heating, set oven thermostat to ‘PILOT’ position, this will turn oven ‘OFF’,but leave oven pilot burner ‘ON’.2. In this position pilot burner will remain alight, but main burner will not operate until thermostatcontrol knob is set to a temperature.3. If pre-heating of oven is required, set thermostat control knob to temperature 190°C and allow 20minutes before cooking in oven to allow oven to warm up.Oven ‘Shut-Down’1. To turn oven to ‘PILOT’ position only, rotate thermostat control knob clockwise until pilot position isreached. In this position only pilot burner will remain on.2. To ‘Shut Down’ oven, depress and turn thermostat control knob to ‘OFF’ position. This will turn‘OFF’ oven and extinguish pilot burner. To re-light pilot burner, refer to ‘Oven Pilot Ignition’ in thissection.Pilot Burnerviewing holesFig 4! IMPORTANT DO NOT USE aluminium foil or trays directly on cast iron sole plate(s). NEVERblock or cover openings on each side of sole plate(s).IMPORTANT:Should any abnormal operation like;- ignition problems,- abnormal burner flame,- burner control problems,- partial or full loss of burner flame in normal operation, be noticed, appliance requiresIMMEDIATE service by a qualified service person and should not be used until such serviceis carried out.