M001XLLPWARNINGUSE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.If you do not understand these directions, or if you have any doubts about the safety of the installation, please call aqualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation maycause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrectassembly or inappropriate use.SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:Dual Mount with Laptop Tray75x75\100x100INSTALLATION MANUAL1-844-SATTLER (18447288537)support@walielectric.comwww.walielectric.com(10kg/22lbs)x2RATEDTIPOVER WARNING● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.Supplied Parts ListLower Polea1 (x1)Upper Polea2 (x1)C-Clamp Bracec (x1)C-Clampb (x1)VESA Platee (x2)M8x12 Boltg (x2)Nuth (x2)M5x14 Boltf (x3)Support Platej (x1)Spring Washerl (x1)M10 Washerk (x1)M10 Bolti (x1)Grommet Base Platem (x1)Wire Clipn1 (x2)Allen Keyo (x1)Wire Clipn2 (x3)M4 Spacers (x8)M4x30 Boltr (x8)Wrenchp (x1)M4x12 Boltq (x8)Swivel Armsd (x1)Laptop Trayt (x1)M4 Nutv (x4)M4x10 Boltu (x4)Option A : Clamp Installation1. Connect Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f andtighten with Allen Key 3mm o .22. Select the preferred height according to your desk thickness. Connect C-Clamp b to C-ClampBrace c using M8x12 Bolt g and tighten with Allen Key 5mm o . Rotate the hand knobclockwise to fasten for stability.Hand Knobacccfoooggbba c foOption B : Grommet Base Installation1. Place Pole a onto Grommet Base Plate m . Connect them from the bottom usingM5x14 Bolt and tighten with Allen Key 3mm .ooaammffLaptop : 17” MaxMonitor: 32” MaxAnti-skid Padw (x4)1a2a2a1a1a1oo31.5'' Pole InstallationLoosen the screw on the Lower Pole a1 with Allen key 2mm o . ConnectLower Pole a1 to Upper Pole a2 and tighten the screw with Allen key2mm o to fix the two poles.a1a1Pre-Assemblyoa2o