Safety Instructions16SAFETY, CONTROL, AND INSTRUCTION DECALSSafety, Control, and Instruction Decals are installed on the machine;if any are missing, illegible, or damaged, a replacement should be ordered and installed beforeputting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.1. Throttle2. Warning – read Operator’s Manual before oper-ating the machine.3. Warning – wear eye and ear protection when op-erating the machine.4. Warning – roll-over hazard• Do not operate on slopes greater than 15degrees.5. Warning – thrown object hazard• Keep bystanders away from the machinewhen operating.6. Warning – entanglement hazard• Keep all guards in place while engine is run-ning.7. Parking brake• Move lever forward to engage ParkingBrake; back to disengage.1. Warning – do not operate the machine without adeck or other implement attached.2. Forward Speed Control• Move lever forward to increase speed; backto stop.3. Warning – read Operator’s Manual before servic-ing or performing maintenance.• Engage parking brake.• Remove ignition key.4. Warning – do not engage PTO clutch with PTOshaft disconnected.5. PTO Clutch Lever• Move lever forward to engage PTO clutch;back to disengage.Location: LH FenderPart Number: 8600-25Location: RH FenderPart Number: 8600-26<15°2.3.4.5.6.7.1.2.3.1.4.5.1. 2.