Wansview NCM625GA User Manual

Contents

Support Email/ Skype: service2@wansview.com 203.4.3 Alarm SettingAlarm DeploymentIO Detection：When tick the IO Detection, user can choose sensor type (Always open or Always close). When user choose Alwaysopen, external alarm device is needed, and when the alarm is triggered, the IO detection will send alarm. If choose Always close,the camera will send alarm continuously per 30 seconds..Motion Detection: Sensitivity can choose Low/ Middle/ High according to needs.Voice Detection: Sensitivity can choose Low/ Middle/ High according to needs.Temperature detection: the temperature range can be set from -100℃ to 100℃(not for this camera)“<”means the temperature below the set value, the camera will send alarm notification.“>”Means the temperature above the set value, the camera will send alarm notification.Humidity detection: the humidity range can be set from 0% to 100%.(not for this camera)“<”means the humidity below the set value, the camera will send alarm notification.“>”Means the humidity above the set value, the camera will send alarm notification.Trigger Alone : The alarm will be triggered for any kind of alarm condition.Trigger Linkage: If set two or more kinds of alarm methods, only met all alarm conditions, the alarm can be triggered.Alarm Action:Save Picture to Email: When an alarm is detected, the camera will send two alarm pictures to the email you set. We support Gmail,Hotmail, Yahoo, Gmx etc.Save Picture to FTP: When an alarm is detected, the camera will send 2 alarm pictures to the FTP server you set, 3-4 pictures willbe sent if the motion is too frequent.Save Record to FTP: When an alarm is detected, the camera will send alarm video to the FTP server you set. The video length isabout 15 seconds for each alarm video, for constant recording, the alarm will be upload to FTP every 30seconds.Save Picture to SD/TF: When an alarm is detected, the camera will send 2 alarm pictures to SD card, 3-4 pictures will be sent ifthe motion is too frequent.Save Record to SD/TF: When an alarm is detected, the camera will send alarm video to the FTP server you set. The video length isabout 15 seconds for each alarm video, for constant recording, the alarm will be upload to FTP every 30seconds.Trigger IO Output:When an alarm is detected, the external IO output device will be linked then send alarm; it doesn't support PoE.Preset Linkage: When an alarm is detected, it will be linked to the camera to Pan/Tilt the camera to the Preset you set.Speaker Linkage:Link the speaker to send alarm when a alarm is detected.Access to “Alarm Setting”, there are options forAlarm Deployment and Alarm action.