Waring WFP16SCD Owner's Manual

Also see for WFP16SCD: Manual Manual Manual

Contents

Waring WFP16SCD Owner's Manual Manual pdf 11 page image

20 21Unit stops running during processing• The unit may have overheated. Refer to Resetting ThermalProtection section (page 15).• Turn unit off and unplug.• Remove bowl attachment.• Remove food being processed from inside the bowl and discard.• Allow unit to cool for 30 minutes.• Reassemble unit, and run first with the bowl empty, then putfood into the bowl and try again.Unit jams or vibrates excessively• Turn unit off and unplug.• Disassemble the batch bowl/accessories.• Make sure there is no food in S-blade hub (if applicable).• Clean food off accessory discs (if applicable).• Reassemble unit, and run first with the bowl empty, then putfood into the bowl and try again.Unit will not come up to full speed• Bowl is overloaded – remove food being processed and reloadusing smaller quantities.If unit does not operate after you have followed the above• Check outlet to be sure there is current.• Check to be sure circuit breaker is on.• Check to be sure the fuse is not blown if there are fuses on thiscircuit.• Call a local Waring service agency.If food processor makes grinding noise• Turn unit off, unplug, disassemble, check bowl and blade to seeif they have been rubbing together.• If bowl and blade are rubbing, call your authorized Waringservice agency.JULIENNE DISC OPERATIONWaring Commercial offers a julienne disc as an optional accessory.Follow the instructions below to operate.• Prepare all food items to be processed by washing and peelingas required. Remove pits, stones, and large seeds. Be sure thefood will fit into the proper feed chute.• If a long horizontal cut is desired – for example, squash sticks –the food must be placed in the feed chute horizontally or on itsside. For finely chopped food results – for example, choppedcelery or finely chopped onions, you must insert the vegetablesvertically or standing up. For a very fine chop of onions, quarterthe onion and gravity-feed it through the chute.Removing processed food from the batch bowl1. Turn the machine off and wait for the blade to stop movingbefore removing the lid and pusher.2. If the blade holds the bowl locked when the motor stops,move the handle of the bowl rapidly back and forth – firstclockwise, then counterclockwise.3. If using a disc, remove before tilting the bowl, using a spatulato scrape off any food sticking to it. If using S-blade, it willstay locked in the bowl when you tilt to pour. Use spatulato scrape food out of bowl. NEVER USE FINGERS TOREMOVE FOOD WHILE BLADE IS IN BOWL.TROUBLESHOOTINGThis section describes potential problems and the correctsolutions for them. Problems that cannot be solved with theguidelines listed below should be referred to one of the WaringAuthorized Service Centers for assistance. A listing of authorizedservice agencies is supplied with each Waring food processor.Unit does not start when assembled correctly• Pull the plug and try plugging into another outlet.• Make sure the bowl is properly positioned on the motor base,that the bowl cover is attached properly, and that the safetyinterlock tab on the cover has properly engaged the safetyinterlock switch.• Press ON button.