IMPORTANT: Collect the water in a container, not the drip tray. Replace the drain cap and hand tighten only.3. Replace the water bottle (see Installing the Water Bottle on pg. 3).Cleaning the Inside of the DispenserTo prevent mineral deposits that can affect the taste and flow of the water, andto ensure proper product performance, your water dispenser must be cleanedevery 4 months.1. Unplug the power cord.2. Remove the water bottle and bottle support collar.3. Drain the reservoir (see Draining the Reservoir on pg. 5).4. Pour a vitapur® water dispenser cleaner or a mixture 4 cups / 1L ofvinegar with 4 cups / 1 L of hot water into the reservoir and wait 20minutes. If using a water dispenser cleaning solution, please follow themanufacturer's instructions.IMPORTANT: To avoid water overflow while cleaning the dispenser,always remove the bottle support collar before pouring water or a cleaningsolution into the reservoir (see Figure A on pg. 3).5. Press both dispensing taps until water no longer comes out.IMPORTANT: Collect the water into a container, not the drip tray.6. Rinse with clean water and drain (see draining the reservoir).7. Replace the bottle support collar and the water bottle (see Installing the Water Bottle on pg. 3).IMPORTANT: Drain approximately 4 glasses of water from each tap before initial use. This does not need to bedone with replacement bottles.Going Away on VacationWhen not using the dispenser for long periods of time or when going on vacation, unplug the dispenser and drain thereservoir (see Draining the Reservoir on pg. 5). Follow Initial Product Cleaning Procedures upon return and startup ofthe dispenser.SPECIFICATIONSCleaning KitAvailable online atwww.greenwayhp.com6WWD224W-2Output per hr: Cold 0.5 gal / 2.0 LInternal Tank: Cold 0.8 gal / 3.2 LCooling Temp (approx.): 8°C / 46°FPower Consumption: Cold 80 W